Cognex In-Sight 7600, Reference Manual

Page: 66 / 113

10. Install the light housing.
CAUTION :
l
Do not hot-plug the LED ring light. Verify the vision system is not receiving power when connecting
or disconnecting the LED ring light.
l
A connector protrudes from the underside of the light housing and can be damaged if placed on a
hard surface.
Note : If a different LED color is required, refer to Replace the LED Ring Light (Optional) on page 56 .
a. Place the light housing with LED ring light on top of the spacer, with “TOP” oriented upward.
b. Verify seating of the gasket on the top of the spacer.
c. There are four captive screw access holes near the white circles on the LED ring light. Use a 2mm hex
wrench to torque the captive screws to 0.34 Nm (3 in-lb).
66
Installation