Cognex In-Sight 7600, Reference Manual

Page: 44 / 113

Mount the Vision System
The vision system provides mounting holes for attachment to a mounting surface.
Note :
l
In the rear housing, the maximum insertion depth of the M3 screws should not exceed 3.5mm. This does not
include the thickness of the mounting material used.
l
In the front housing, the maximum insertion depth of the M4 screws should not exceed 3mm. This does not
include the thickness of the mounting material used.
For more information, see 7500/7600 Series & 7800/7801/7802/7900/7901/7902 Vision System on page 95
and 7802P/7902P/7905 Vision System on page 99 .
CAUTION : The vision system should be grounded, either by mounting the vision system to a fixture that is
electrically grounded or by attaching a wire from the vision system’s mounting fixture to frame ground or Earth
ground. If a ground wire is used, it should be attached to one of the four mounting points on the back plate of the
vision system and not to the mounting points on the front of the vision system.
1. Align the holes on the mounting surface with the mounting holes on the vision system.
2. Insert the M3 screws into the mounting holes and tighten using a 2.5mm hex wrench. The maximum torque is
0.90 Nm (8 in-lb).
44
Installation