Cognex In-Sight 7600, Reference Manual

Page: 56 / 113

Replace the LED Ring Light (Optional)
The illumination accessory (ISLM-7000-WHI) has a white LED ring light pre-installed. Complete the following steps to
replace the pre-installed LED ring light.
CAUTION :
l
Do not hot-plug the illumination accessory. Verify the vision system is not receiving power when connecting
or disconnecting the illumination accessory. Failure to remove power during this procedure may result in
damage to the vision system and/or the illumination accessory.
l
Tighten all illumination accessory screws in the following sequence.
1. Remove power from the vision system.
2. Use a 2mm hex wrench to remove the four M3 x 12mm screws and remove the cover.
56
Installation