English
36
MBER
:
COMMUNICATION Error
This message indicates that the motherboard within the unit is not communicating properly with the con-
trol source. Check the connectors located on both boards.
OPER
:
PAN ENCODER Error
This message indicates that there is a problem with the PAN encoders. Check the sensors on the encoder
wheel located near the pan movement motor, as well as the relevant cabling.
OTER
:
TILT ENCODER Error
This message indicates that there is a problem with the TILT encoder locate on the fixture yoke. Check the
sensors on the encoder wheel located near the pan movement motor, as well as the relevant cabling.
SNER
:
LINE SYNC Error
Check and eventually replace opto-isolator U9.
LAER
:
LAMP Error
The lamp has turned off unexpectedly, without any signal from the controller to do so. The system may
have exceeded the allowable number of attempts to ignite the lamp (7) after which number the system is
designed to protect ignitor, cabling and the lampholder by reducing the incidence of lamp ignition volta-
ges to these components. Check and eventually replace the lamp if it is faulty, damaged, or has exceeded
its lamp life.
EPER
:
EEPROM Error
The EEPROM is either defective or absent; refer to your
coemar
service centre for a replacement compo-
nent.
DTER
:
DATA Error
The initial parameter settings are incorrect or corrupt; the projector has reloaded its factory default settings.
Turn the projector off and on again. Should the error reoccur, refer the unit to your authorised
coemar
service centre to have the EEPROM check and possibly replaced.
SRER
:
RESET CIRCUIT SENSOR Error
Check the cabling and the circuit for the RESET sensor
COER
:
COLOUR WHEEL POSITION Error
Check the cabling and the sensor on the COLOUR wheel, the sensor and circuit board indicate an error.
RGER
:
GOBO WHEEL POSITION Error
Check the cabling and the sensor on the GOBO wheel, the sensor and circuit board indicate an error.
ER20
÷
ER99
:
SYSTEM Error
Turn the unit off and on again. If the error persists, contact your authorised
coemar
service centre.
HEAT
:
LAMP OVERHEAT Indicator
The projector is attempting to ignite a lamp, which is still too hot to strike. Wait until the lamp has cooled
further and then attempt to reignite the lamp.
All the components of the
ProSpot 150 LX
are available as spare parts from your
coemar
service centre.
Accurate description of the fixture, model number, and type will assist us in providing for your requirements in an efficient and effec-
tive manner.
26. Spare parts
25 Error messages
