26
English
ProSpot 150 LX
is able to record 9 programs of up to 16 scenes each.
To record programs, the projectors must be connected as described in section 8,2 “
operation via dmx 512
”.
Each
ProSpot 150 LX
utilises in standard mode
13
channels of DMX signal for the complete control of all functions. (see section 12.2);
when recording programs, it utilises 17 channels, the first 13 as normal followed by 4 more which are used to record programs.
You should ensure that the units to be programmed are addressed in multiples of 17 and have available a controller to program
with.
15.1 addressing
When first turned on, projectors will be addressed as
A001
indicating the address
DMX 1
; a projector thus addressed will respond
to (for the purpose of programming) channels
1
to
17
of your
DMX 512
controller. The second unit should be addressed as
18
,
the third as
35
and so on until the final
ProSpot 150 LX
.
DMX addresses can be altered as shown in section 12 of this manual.
15.2 DMX programming channels
Four dmx channels are utilised exclusively for programming, and these follow immediately the 13 used for normal function control.
when the unit is set to “
REC
” mode; ensure you controller is able to address these channels:
coemar
factory presets the units with program
P.1
which can be over-written, but which remains in memory permanently and may
be recalled as the default program.(see section.
11. Setting the
ProSpot 150 LX
to operate automatically - “Erasing a
recorded program”.
channel
function
type of control
effect
decimal
14
Program "to be
recorded" selection
step
no effect
0-9
step
Program 1
10-37
step
Program 2
38-65
step
Program 3
66-93
step
Program 4
94-121
step
Program 5
122-149
step
Program 6
150-177
step
Program 7
178-205
step
Program 8
206-233
step
Program 9
234-255
15
Step selection
step
no effect
0- 9
step
Memory 1
10-25
step
Memory 2
26-41
step
Memory 3
42-57
step
Memory 4
58-73
step
Memory 5
74-89
step
Memory 6
90-105
step
Memory 7
106-121
step
Memory 8
122-137
step
Memory 9
138-153
step
Memory A
154-169
step
Memory B
170-185
step
Memory C
186-201
step
Memory D
202-217
step
Memory E
218-233
step
Memory F
234-249
step
Memory G
250-255
16
Record enable
step
Recording mode "disabled" (FIXTURE NOT RECORDING)
0-19
step
Recording mode "enabled" (FIXTURE RECORDING), in combination with ch 17
20-234
step
End of recording mode, sets program length; if not used the length will
always be 16 memories (in combination with ch 17)
235-255
17
ENTER
step
Enter enable, to record a memory you must change this value to 255 and
then back (channel 16 must be between 20/234)
0-128
step
Enter, store the dmx value into the selected step and program (channel 16
must be between 20/234)
129-255
15. Recording programs to the internal memory of the ProSpot 150 LX
