Code PHANTOM 1024, User Manual

Page: 37 / 46

Phantom_1024_V2.023_en.PDF http://www.codelight.com 31
8.2.1.2. Setup Fixture Info
Press S1 [Setup Fixture Info];
Set up the name of the fixture by at most 20 characters of English letters or Numbers.
Use the Unit buttons to input the English letters and the Numeric keypad to input
Numbers. Press Enter after finish;
Input the name of the manufacturer, at most 14 characters. Press Enter after finish;
Input the total Number of DMX channels.
8.2.1.2.1. Setup Dimmer & Pan/Tilt
Note
：
you can skip this setup menu
，
and enter the [Channel Attribute] directly belowed.
Press S2 [Dimmer & Pan/Tilt Setup];
Input Dimmer channel Number;
Input Dimmer Low channel Number;
Input Tilt channel No;
Input Tilt Low channel Number;
Input Pan channel Number;
Input Pan Low channel Number;
You should acknowledge that you need to input the channel Number with “Low” only when
the dimmer, Tilt and Pan channel of fixtures are16 bit. For those with 8 bit, you should input 0
or press Enter directly.
8.2.1.2.2. Channel Attribute
Press S3 [Channel Attribute];
Use
、
button to move to the unwritten data channels;
Input the channel name by one of the two ways:
1. Input by using the Unit keys and Numeric keypad;
2. Press the blank key in the Numeric keypad, and a common channel name list will pop
up, use
、 、  、
to select and press [Confirm];
Press the buttons in the Attribute section to distribute the Attribute buttons, (e.g. if the
channel is Gobo, then press Gobo ) ;
Set up the parameters such as control wheels, press the Attribute buttons to assign the
control wheels to control its channel value:
Press it once, use control wheel A to control its value;
Press it twice, use the control wheel A to control the fine 8 bit of the attribute (the
fixture must be in 16 bit);
Press it 3 times, use control wheel B to control its value;
Press it 4 times, use control wheel B to control the fine 8 bit of the attribute (the fixture
must be in 16 bit) ;
Press [Save and Exit] to complete the attribute setup.