Code PHANTOM 1024, User Manual

Page: 30 / 46

Phantom_1024_V2.023_en.PDF http://www.codelight.com 24
6.8. Pre-position the LTP
In the “Live Show Mode” menu, press S2 [Pre-position the LTP], LCD will display as follow:
In this state, press and hold still the flash button on top of
Playback fader, raise the fader, the console will not open the
dimmer of the moving fixture. It will output the PAN/TILT,
GOBO and COLOUR first. Once release the flash button, the
dimmer will be turn on immediately.
6.9. Playback Parameter
Firstly, fade in the Playback fader, and press S1 [Playback Parameters] under “Live Show Mode” to enter the
menu for changing the Playback parameters. The upper part of the LCD screen display the current Playback
number. The edit here of direction change, fade in time and link mode are for the current Playback. If you need to
edit another Playback button, please Press Shift + the Playback button you need.
6.9.1. Change the Direction of Chase
If the current Playback is a Chase, press S2 [Change Run Direction] to change the direction of the Chase,
which equals the function of pressing Go+ and Go-.
6.9.2. Change Link mode
When programming Chase, you may notice there is a “Link” entry on the LCD screen, which shows the
link mode of each Chase step. “Link = ON” means the console will run the new Chase step after finish the
present step; While “Link=OFF” means the present step will pause after finish, and you need to press Go+
or Go- to run the next step.
Press S4 [Change Link mode] to switch between the 3 modes (“Link mode = Automatic”, “Link mode =
Manual”, “Link mode = Inside”) of the current Playback.
Inside ----- run as the Link state of chase step;
Automatic ----- run continuously regardless to the Link state of each step;
Manual ----- Chase steps will pause after finish running and wait for your “Go” order. In this state,
after fade in the fader, the corresponding button becomes a manual operation, the chase will run one
step once you press the button.