![background image](http://html1.mh-extra.com/html/club-car/1995-golf-car/1995-golf-car_maintenance-service-supplement_2626736036.webp)
Removing The On-board Computer, Continued:
3. Disconnect the No. 10 black wire (to the OBC) from the back of the charger receptacle (Figure 17-15).
4. Disconnect the gray wire (from the OBC) at the sense lead fuse, leaving the sense lead fuse connect-
ed to the grey lead from the charger receptacle (Figure 17-15).
5. Remove the No. 18 red and yellow wires on the solenoid.
6. Disconnect the No. 6 and No. 10 black wires from B- of the controller (Figure 17-16).
7. Disconnect the No. 18 brown wire from OBC.
8. Remove the two 7/16 lock nuts holding the OBC.
9. Remove the OBC from the car.
Installing the on-board computer:
Install the OBC in reverse order of removal.
SOLID STATE SPEED CONTROLLER
Testing the speed controller:
See Test Procedure 10, Page 17-18.
Removing the speed controller:
1. Disconnect the batteries (Figure 17-1, Page 17-2).
2. Discharge the controller (See instructions in Warning Box on Page 17-25).
3. Remove all the No. 6 wires connected to the controller (Figure 17-16).
17-34
WARNING
• FAILURE TO DISCHARGE THE CONTROLLER COULD RESULT IN A SHORT SHOULD THE
WRENCH OR RATCHET TOUCH THE LARGE POST ON THE SOLENOID.
GREY LEAD WITH
MALE CONNECTOR
FUSE ASSEMBLY
CHARGER
RECEPTACLE
GREY WIRE
FROM OBC
NO. 10 BLACK
WIRE TO OBC
B-
TERMINAL
NO. 6 BLACK
NO. 10 BLACK
LOCK NUTS
FIGURE 17-15
FIGURE 17-16
Summary of Contents for 1995 Golf Car
