![background image](http://html1.mh-extra.com/html/club-car/1995-golf-car/1995-golf-car_maintenance-service-supplement_2626736014.webp)
CONTROL CIRCUIT
Test Procedure 1 - Batteries / Voltage Check:
1. With VOM set at Volts DC, place red (+) probe on the positive post of battery No. 1, and the black (-)
probe on the negative terminal of battery No. 6. If you don’t read at least 48 volts with the batteries fully
charged, check for loose battery connections or a battery installed in reverse polarity. Refer to Batteries,
Section 18, for further details on battery testing.
Test Procedure 2 - Key Switch:
Vehicle with Multi-step (wiper switch) Potentiometer -
1. Place the red (+) probe of the VOM or continuity tester on the large terminal of the solenoid (with red
wire attached) and place the black (-) probe at the blue wire disconnect terminal on the key switch side.
2. With the key switch off, the reading should be no continuity. If continuity is shown, perform Test
Procedure 4. If a correct reading is not obtained for Test Procedure 4, check the key switch, wires and
terminals, and then replace defective parts.
3. Insert the key and turn the switch on. The reading should be continuity.
4. If the reading is incorrect, check the key switch, wires and terminals, and then replace defective parts.
Vehicle with Continuously Variable Potentiometer -
1. Place the red (+) probe of the VOM or continuity tester on the large terminal of the solenoid (with red
wire attached) and place the black (-) probe at the green/white wire from the Forward/Reverse limit
switch No. 1.
2. Depress and hold the accelerator pedal to the floor to activate the accelerator pedal limit switch.
3. With the key switch off, the reading should be no continuity.
4. Insert the key and turn the switch on while continuing to hold the accelerator pedal down. The reading
should be continuity.
5. If the reading is incorrect, check the key switch, wires and terminals, and replace defective parts.
17-12
WARNING
• WHEN MAKING ELECTRICAL TESTS OR REPAIRS, ALWAYS:
- WEAR SAFETY GLASSES OR APPROVED EYE PROTECTION.
- REMOVE KEY.
- PUT F&R SWITCH IN NEUTRAL.
- DISCONNECT BATTERIES AS SHOWN, FIGURE 17-1, PAGE 17-2.
- FOLLOW ALL PROCEDURES EXACTLY AS STATED.
• SEE SAFETY WARNINGS PAGE 17-1.
WARNING
• TO AVOID UNTINTENTIONAL STARTING OF THE VEHICLE, DISCONNECT BATTERIES AS
SHOWN IN FIGURE 17-1, PAGE 17-2, AND THEN DISCHARGE THE CONTROLLER AS FOL-
LOWS:
- TURN THE KEY SWITCH TO “ON” AND PLACE THE FOWARD/REVERSE LEVER IN THE
REVERSE POSITION.
- SLOWLY DEPRESS THE ACCELERATOR PEDAL AND KEEP IT DEPRESSED UNTIL THE
REVERSE WARNING BUZZER CAN NO LONGER BE HEARD. WHEN THE BUZZER STOPS
SOUNDING THE CONTROLLER IS DISCHARGED.
Summary of Contents for 1995 Golf Car
