35
FIG. 4
FIG. 3
of the mounted plate (where the arrow is). Squeeze the two hinge pieces until they snap together
(See FIG. 3 close up)
.
8. Mark hole locations and attach middle hinges for full length doors.
(See Steps 1 1-7)
9. Gently close the door against the unit. (Hinges may be separated by squeezing the Release Button on the end
of the hinge arm.)
10. Position the door handle template (#05-90050) on the door front to align with the bottom edge of inner door
panel (raised or flat). Drill a 1/16 in. pilot hole through the corresponding handle hole(s) on front of door. Turn
the door over and drill a 3/16 in. hole for handle at pilot location(s).
NOTE:
Door faces may be adjusted up and down by loosening the hinge plate’s fixing screws and sliding the door up and down then
tightening the fixing screws again. The width of the gap between the doors may be adjusted by tightening or loosening the adjustment
screw on the front of the hinge arm.
(See FIG. 4)
NOTE:
A suggested combination use of Soft and Standard close hinges should be used for proper closure of doors.
Tower Doors
DOOR & DRAWER ASSEMBLY
FIG. 2
FIG. 5
FIG. 1
NOTE:
photo shows how a hinge opens to drop into door pocket.
Summary of Contents for MasterSuite
