31
Hamper Door
DOOR & DRAWER ASSEMBLY
INSTALLATION
1. (See FIG. 1)
2. Insert each hinge into a set of three (3) holes on the back of the
hamper door, then turn the fastening screw one quarter turn
clockwise (as shown with arrows on the hinge) to tighten in place.
(See FIG. 2)
3. Position the Hamper Door face down on the floor directly in front
of the shelf tower. Mount one flap stay on each side of the door
using the enclosed #8 x 5/8 in. screws. Attach the basket hook
(posts up) to the pre-drilled holes in the door using the #8 x 1/2 in.
screws.
4. To fasten each hinge to a hinge plate, hold the door with the hinges
attached so that the hooks on the back of each hinge latch onto
the front, leading edge of the mounted plate (where the arrow is).
Squeeze the two hinge pieces until they snap together.
(See FIG.
3)
(Hinges may be separated by squeezing the Release Button on
the end of the arm.)
5. Hold the door 90 degrees to the shelving unit until the flap stays
have been attached to the partitions in the 7th and 8th system
holes (counting up from the bottom shelf) using Euro screws.
(See
FIG. 4)
6. Choose your handle size and drill a 1/16 in. pilot hole through
each corresponding dimple on the back of the hamper door.
Then, from the front of the door, drill a 3/16 in. hole for handle at
pilot location(s). NOTE: It is important to drill both the pilot hole
through the back and the larger hole through the front to prevent
chipping.
(See FIG. 4)
7. Slide the 17 in. high wire basket onto the basket hook and close
the door.
NOTE:
Door face may be adjusted left and right by loosening the hinge plate’s
fixing screws and sliding the door side to side, then tightening the fixing screws
again. The width of the gap between the doors may be adjusted by tightening or
loosening the adjustment screw on the front of the hinge arm.
DESCRIPTION
Hamper Door
(contoured, raised
panel or solid wood)
Basket Rail
PARTS
QTY
1
1
Back Panels
Shelving /Towers
}
Drawers and Doors
Adjustable Shelves
Molding
Baskets, Valet Rods,
Tie & Belt Racks, and
other accessories
Islands
Benches
ORDER OF ASSEMBLY
Summary of Contents for MasterSuite
