25
Single & Double-Wide Hutch
SHELVING/TOWER ASSEMBLY
PARTS
4. Mark and trim the bottom of the middle vertical panel from the bottom end of the panel, plus 3/8 in. above the
center of the nearest system hole. Discard the trimmed middle section of the original panel.
5. Through-drill all assembly holes on these top and bottom panel pieces. (If you are fastening drawer runners or
basket slides on either side of this panel, you must thru-drill all holes for mounting runners as well.)
6. Assemble double-wide hutch tower in its final location, following the basic steps in the single hutch assembly
above, using the pieces shown at right. This may require a second installer.
(See FIG. 4)
7. Install the second toe kick per “Toe Kick” instructions in “Shelving/Tower Assembly” section once the double-
wide tower is in its final location.
8. To install double-wide hutch upper section, work from the left to the right. Secure the first upper cleat to the
left vertical panel. Next, remove a dowel from the other side of the cleat (bottom dowel is removed in
FIG. 5
).
Hang the middle upper panel from this cleat using one (1) HiLow screw countersunk through the middle panel
into the left cleat.
(See FIG. 5)
9. Remove the opposite dowel from the second upper cleat (upper dowel is removed in
FIG. 5
). Install the
second upper cleat into the middle vertical panel (
FIG. 5)
with one (1) HiLow screw from the right vertical
panel into the right cleat.
10. Fasten all remaining cleats, toekicks and fixed shelves to
outside left and right panels snugly.
11. If you have upgrades or accessories with drawer or
basket runners, or door hinges, fasten the runners
and/or hinges. (See appropriate upgrade or accessory
assembly instructions for details.)
12. Level the hutch tower(s). If necessary add shims
underneath one or more vertical panel(s).
13. Assemble and install the upgrades and/or accessories
(drawers, doors, hampers) in the hutch. Re-level the
hutch tower, if necessary.
14. Fasten the hutch to the closet’s wall with the
appropriate screws through the top cleat.
(FIG. 3)
(See
“Working with Different Wall Types” in Installation
Manual for details.)
15. Install the adjustable shelves using safety shelf pins
.
* Hutch drawings may vary slightly
from actual product.
Summary of Contents for MasterSuite
