19
FIG. 1
TRIM EACH 30 in. CLEAT TO 29-3/8 in.. THEN, DRILL
HOLES FOR TWO (2) DOWELS AND ONE HOLE FOR
ONE (1) HI-LOW SCREW
Unfinished Edge
Finished Edges
30Ó
29-3/8Ó
2.13Ó
54mm
.87Ó/22mm
3.39Ó
86mm
8mm
4mm
Corner Tower
SHELVING/TOWER ASSEMBLY
4. Add adjustable shelves (6 shelf pins per shelf) or hanging
bars as desired. (See “Top Shelf and Pole” in “Shelving/
Tower Assembly” section for additional instructions.)
• Continue with installation of other towers. You may
not install corner towers using the rail hanging
MasterSuite system.
• We recommend cutting one (or more) 30 in. cleat(s) to
support and square one side of the corner tower section.
Prior to assembly, cut a 30 in. shelf tower cleat to 29-3/8
in. wide and drill out dowel (8mm) and HiLow Screw (4
mm) holes.
(See FIG. 1)
FIG. 2
FIG. 3
Not less
than 28"
Cut out
on right
side
Cleat
Adjustable
shelf
Screws
NOTE:
For purposes of
illustration, Fig. 3 does
not show option of
cammed fixed top shelf
or hanging.
Summary of Contents for MasterSuite
