Clockaudio CDT100 MK3, Manual

Page: 20 / 46

2 0
CLOCKAUDIO CONTROL PANEL
The Clock Audio Control Panel for Windows computers provides additional
functions for setting up the CDT100 MK3. This section describes some of
the basic controls but is not intended to be exhaustive. Please consult the
Clockaudio Control Panel manual for additional functionality.
The Clockaudio Control Panel application will need to communicate to
the CDT100 MK3 over the network. All Dante devices will be discovered
regardless of the IP address setup on the PC, however, communication with
the CDT100 MK3 Windows application requires a compatible IP addresses.
By default, the CDT100 MK3 will receive a dynamic IP address. If there is
no DHCP server to assign an IP address, the device will self-assign an IP
address. This IP address will always start with 169.254.x.x.
To ensure communication, the Windows PC running the CDT100 MK3
application must be on the same subnet as the CDT100 MK3 device.
CLOCKAUDIO CONTROL PANEL
CONFIGURATION
DEVICE SELECTION
Depending on the configuration, multiple CDT100 MK3 units may be active
on the network. Use the Dante Devices window on the left side to select a
CDT100 MK3 unit to setup.
DEVICE INFO
This section displays the product name, unique identifier, IP addresses and
Mac address.
Dante IP: IP address of the CDT100 MK3 on the Dante Network.
Control IP: IP address of the CDT100 MK3 for addressing with an external
controller
Identify: Flash the front-panel LED indicator of the selected CDT100 MK3.