Clockaudio CDT100 MK3, Manual

Page: 36 / 46

3 6
1.3.10 Firmware Update
The Firmware Update command reboots the CDT100 into an update mode. The command
has no parameters.
FWUPDATE
Response:
None – the unit will immediately re-boot and the LED will change to yellow.
1.3.11 Boot Version
The BVERSION command returns the current version of the Host MCU boot-loader firmware.
The command has no parameters.
Request the MCU boot-loader firmware version:
BVERSION<CR>
Response:
ACK BVERSION x.y<CR>
Where x is the major version number and y is the minor version number of the
boot-loader.
1.3.12 Set TS State
The Set TS State command provides for setting the state of the Red or Green LEDs on either
all four TS ports, or a selected TS port.
The following command sets the Red LEDs on all four TS ports to on:
STS 0 R=1<CR>
Response:
ACK STS 0 R=1<CR>
The following command sets the Red LED on TS port 1 to off:
STS 1 R=0<CR>
Response:
ACK STS 1 R=0<CR>
The following command sets the Green LEDs on all four TS ports to on:
STS 0 G=1<CR>
Response:
ACK STS 0 G=1<CR>
The following command sets the Green LED on TS port 4 to off:
STS 4 G=0<CR>
Response:
ACK STS 4 G=0<CR>
The following command sets the Blue LED on TS port 4 to on:
STS 4 B=1<CR>
Response:
ACK STS 4 B=1<CR>