Clockaudio CDT100 MK3, Manual

Page: 29 / 46

2 9
1 UDP COMMAND SYNTAX
The following commands are available for the CDT100 MK3. Commands are sent to UDP
port 49494 on the target device. Responses are returned to the sending UDP port number.
Please keep in mind that UDP is not a “guaranteed delivery” protocol, so it is possible for
commands and responses to be occasionally lost. Clients should take appropriate mea-
sures to handle dropped packets.
1.1 CDT100 MK3 Command Set
Description Command Param 1 Param 2
Phantom Power PP Channel # (x)
x = 0: All Channels
x = [1..4] State (0 = off or 1 = on)
Identify Device ID Mode (0 = off, 1 = on) -
Find Unit FU - -
Load preset values LOAD x (x = 0) -
Save preset values SAVE x (x = 0) -
Version Info VERSION - -
Retrieve current settings QUERY - -
Reset to factory defaults DEFAULTS - -
Set ARM-C State SARMC 0 = Off, 1 = On -
Get ARM-C State GARMC - -
Set Async IP Address SASIP xxx.xxx.xxx.xxx:yyyy
Get Async IP Address GASIP -
Firmware Update FWUPDATE -
Boot Loader Version BVERSION -
Set TS State STS TS # (x)
x = 0 : All channels
x = [1...4] R=(0 = off or 1 = on)
or
G=(0 = off or 1 = on)
or
B=(0 = off or 1 = on)
Get TS Status GTS TS # (x)
x = 0 : All channels
x = [1...4]