Clockaudio CDT100 MK3, Manual

Page: 33 / 46

3 3
1.3.3 Load/Save
The LOAD and SAVE commands allow different configurations to be saved into preset 0.
When the CDT100 starts up preset 0 is used as the default configuration. A preset saves
the CDT100 configuration, including the phantom power settings, the TS brightness settings
and the ARM-C setting. In preparation to save a preset the various commands (PP, STSB,
SARMC) are sent to the CDT100 to configure it into the desired state, then the SAVE com-
mand is issued to save that configuration to a preset. Attempting to LOAD a preset that has
never been saved will result in a NACK being returned.
Save the current CDT100 settings to preset 0, which would then be used as the
startup settings.
SAVE 0<CR>
Response:
ACK SAVE 0<CR>
1.3.4 Version
The VERSION command returns the current version of the Host MCU firmware. The com-
mand has no parameters.
Request the MCU firmware version:
VERSION<CR>
Response:
ACK VERSION x.y<CR>
Where x is the major version number and y is the minor version number
The VERSION command only returns the version of the Host MCU firmware. For the version
of the Ultimo (Dante) firmware the Dante Controller application should be used.
1.3.5 Query
A QUERY command allows the control system to get a snapshot of the current state of the
Phantom Power for all channels and the current Identify Mode. The command has no
parameters.
Request the Phantom Power and Identify Mode:
QUERY<CR>
Response:
ACK QUERY PP1=OFF PP2=ON PP3=OFF PP4=OFF ID=OFF<CR>
This response shows that channels 1, 3 and 4 Phantom Power is off, Channel 2 Phantom
Power is on and the Identify Mode is off.
1.3.6 Defaults
The DEFAULTS command sets phantom power on all channels to off, places the TS LEDs out-
puts in the inactive state and sets the ARM-C control output to the inactive state. This state
is then stored to preset 0.
To set the CDT100 so that preset 0 has factory settings:
DEFAULTS<CR>
Response
ACK DEFAULTS<CR>