Clockaudio CDT100 MK3, Manual

Page: 18 / 46

1 8
ADJUST PREAMP GAIN
Each of the four microphone preamps has an independent gain control.
When set fully counter-clockwise, the gain is set to a fixed level and will click
into place. Turn the gain knobs as needed to adjust each microphone.
TOUCH SWITCH PORT SETUP
The TS PORT allows users to connect a Touch Switch such as the TS 003 or
TS 005 to the CDT100 MK3.
To test Touch Switch configuration, use the Clockaudio Control Panel
application. Please consult the Clockaudio Control Panel manual for
detailed instructions.
FRONT PANEL SWITCHES &
DEMO/DIAGNOSTIC MODES
The front-panel TEST button allows the user to switch between Normal
operation, TS Port Test Mode and Demo Mode.
TS PORT TEST MODE: While in normal operation, press and hold the
TEST button for 5 seconds to activate TS Port Test Mode. In this mode,
each connected Touch Switch will turn RED. Each time the Touch Switch
is touched, the color will cycle. This allows testing of connected Touch
Switches and LEDs.
DEMO MODE: While in TS Port Test Mode, press and hold the TEST button
for 5 seconds to active Demo Mode. In this mode, each Touch Switch
connected to a TS PORT will illuminate, cycling through the color spectrum.
To return to Normal Operation, press and hold RESET for 5 seconds.
ADDITIONAL TEST MODES
Two additional modes, a VU meter mode and a Latency test mode can be
accessed with the Clockaudio Control Panel Control Panel application.
Please consult this portion of the manual for more information.