Clockaudio CDT100 MK3, Manual

Page: 12 / 46

1 2
CONNECT TOUCH SWITCHES
The TS PORT allows users to connect a Touch Switch such as the TS 003 or
TS 005 to the CDT100 MK3 for microphone muting and unmuting.
Each TS Port can be connected to a single Touch Switch. Configure the
functions of each switch with the Clock Audio CDT100 MK3 Windows
Application.
TS PINOUT DIAGRAM
PIN 1 Logic Input (3.3V logic high) to detect the Reed
switch on Clockaudio CRM series microphones
PIN 2 Negative (-) lead for RED LEDs on Clockaudio
devices
PIN 3 Common Ground for LED, Switch operation, &
Reed switch ground
PIN 4 12V (+) supply for LED and Switch operation on
Clockaudio control devices
PIN 5 Logic Input (3.3V logic high)
PIN 6 Negative (-) lead for GREEN LEDs on Clockaudio
devices
PIN 7 Negative (-) lead for BLUE LEDs on Clockaudio
devices
PIN 8 Logic Input (3.3V logic high) for user defined logic
Input
MIC 1 MIC 2 MIC 3 MIC 4 OUT 1 OUT 2
PORT 1 PORT 2 CDT100 MK3 TS1 TS2 TS3 TS4
22
12 30
40
DEFAULT GAIN
22
12 30
40
22
12 30
40
DEFAULT GAIN
22
12 30
40
DEFAULT GAIN`
DEFAULT GAIN
POWER TEST RESET
CDT100 MK3
1 2 3 4 5 6 7 8
FEMALE XLR
(front view)
JACK VIEW
Pins 1, 5, and 8 are Switch Logic Inputs (GPIOs). These are
pins that the DSP or control system reads the Hi/Low status
and reacts as programmed (3.3V, switch for Clockaudio
control devices is Pin 5)
Pins 2, 6, and 7 act as GPI/O Outputs or relays/contact
closures, that ground to Pin 3, the common ground.
PIN 3 is the Common Ground.
PIN 4 is the 12V supply for LED power and switch operation.