©
2008
Directed Electronics All rights reserved
11
Valet/Program Switch, 2-Pin BLUE Plug
The Valet/Program switch should be accessible from the driver’s seat. It plugs into the BLUE port on
the side of the unit. Since the system features Valet by using the remote transmitter, the switch can
be well hidden. Consider how the switch will be used before choosing a mounting location. Check
for rear clearance before drilling a 9/32-inch hole and mounting the switch.The GRAY wire in the
two-pin plug may also be used as a (+) ghost switch input and can be connected to any (+) switch in
the vehicle. (See
Feature Descriptions
section of this guide.)
Programmer Interface, 3-Pin BLACK Plug
The BLACK three-pin port is provided for programming of the unit. When using the 998T
Bitwriter
®
, it is possible to configure any and all of the programmable functions. For more infor-
mation please refer to the guide packaged with the programmer. This port can also be used to interface
with Directed Video components for on-screen security system programming and trigger information.
Mounting the Receiver/Antenna
Receiver/antenna position should be discussed with the vehicle owner prior to installation, since the
antenna may be visible to the vehicle’s operator.
The best location for the receiver/antenna is centered high on either the front or rear windshield.
For optimal range, the antenna should be mounted vertically. It can be mounted horizontally in
relation to the windshield or under the dashboard away from metal, but range will be diminished.
Metallic window tint can also affect range, so this should be a consideration when determining the
mounting location.
After determining the best mounting location, follow these steps:
1. Clean the mounting area with a quality glass cleaner or alcohol to remove any dirt or residue.
2. Plug the receiver/antenna cable into the receiver/antenna.
N426P_2008-08.qxd 8/14/2008 10:40 AM Page 11
U
K
A
pproval Auth
or
it
y
24-Mar-10
