© 2007 directed electronics
43
Note #4: PIN Programming
A PIN code can have one to four digits; each digit can be from 0-9.
N
NO
OTTEE:: A PIN code cannot begin with a zero.
z
Programming Procedure
1.
Enter the feature location in the user-selectable programming grid.
2.
Immediately press and release
of the PlainView 2 Valet switch.
3.
Select each digit by pressing
1-9 times, and then press
to enter
the number into the system. To enter a zero, press
only.
z
To program a PIN code of 1032:
1.
Press and release
once and
once. You will hear one chirp.
2.
Press and release
once. You will not hear a chirp after programming
a zero.
3.
Press and release
three times, and then press
once. You will hear
three chirps.
4.
Press and release
two times, and then press
once. You will hear
two chirps.
5.
Wait for two siren chirps after a five second pause or five seconds after the
last digit has been entered if using less than four digit code number.
6.
Turn off the ignition; the siren will chirp three times.
7.
The programming mode is now exited.
z
PIN Code Confirmation Procedure
Begin this procedure within 15 seconds of finishing the programming sequence
or the new code will not be set.
1.
Turn on the ignition.
2.
Enter the new PIN code.
3.
Press and hold
for three seconds.
z
LED turns on: New PIN code is learned and programming is
complete.
z
LED stays off: New PIN code is not learned and the system reverts to
the old PIN code. Repeat the programming sequence.
N919730P_01-07.qxd 1/12/07 3:41 PM Page 43
U
K
A
pproval Auth
or
it
y
24-Mar-10
