© 2007 directed electronics
27
tilt sensor
The 507C tilt sensor detects when the vehicle is being raised in an attempt to either
remove the wheels/tires or tow the vehicle. It is capable of independently learning the
vehicle’s initial angles of vertical and horizontal inclination each time the vehicle is
parked, ensuring the most accurate tilt (vertical) and motion sensing (horizontal) pos-
sible.
The sensor control module must be mounted at an angle no greater than 45 degrees,
with respect to the horizontal plane of the vehicle, and it must be mounted with the
case top facing upward. We recommend mounting the control module to the floor of
the vehicle. To mount the control module, fasten the unit with either Velcro or screws.
Plug the sensor into the Black T-harness connector. It will report zone 3 if triggered.
NOTE:The Tilt sensor should not be mounted in any place where rapid temperature
changes could affect it such as centre console above vehicle exhaust pipe.
glass tamper sensor
The 506T Glass Tamper Sensor is a low-current device that provides an added level of
protection to an existing security system by detecting sounds that have the acoustic sig-
nature of breaking glass or metal-to-glass impacts. It consumes less than 1 mA of cur-
rent. Plug the sensor into the White T-harness connector. It will report zone 8 if trig-
gered.
remote adjustable proximity sensor
The proximity sensor input circuitry has been improved for G5 so the sensor only has
power when the alarm is armed. While driving this protects highly sensitive vehicle
electronics (i.e. radar detectors) that can be affected by outside interference. However,
this does change the way the sensor is adjusted but will not affect normal operation
of the sensor.
Inside the vehicle's headliner is the optimal mounting location for this sensor and
should always be the first choice. The sensor should face down, centered side to side,
with the wire harness exiting toward the front or rear of the vehicle.
If headliner mounting is not possible, the sensor can be placed in a lower area of the
vehicle, but field size and sensitivity may be affected. The center console may be
appropriate.
Plug the sensor into the Proximity sensor port on the side of the control unit using the
shielded 3-wire harness. It will report zone 1 if triggered.
N919730P_01-07.qxd 1/12/07 3:41 PM Page 27
U
K
A
pproval Auth
or
it
y
24-Mar-10
