35
Revision date: 09.18.14
CLEARSPAN
™
GRO-MAX GOTHIC HIGH TUNNELS
INSTALL ROLL-UP DOOR PANEL ROPES
The roll-up panel ropes are laced through the roll-up panel.
These ropes wrap around hook lags that are screwed into
the sides of the door frame. When installed correctly, these
ropes help to keep the roll-up panel in place when it is fully
or partially closed. These steps describe one way to lace
the roll-up panel.
Gather the parts:
• Hook lags (#FAX120)
• Rope (#CC5505)
• Zipper extension pole (#CC2235)
1. Beginning on the
outside of a door frame
, attach a
hook lag between the first two grommet holes below
the bracket. Position the open end of the hook lag
towards the end panel.
IMPORTANT:
Screw hook lags into the sides of the
door frame, not the front.
Do not screw into the roll-up
panel.
2. Install a hook lag at every other grommet interval as
shown in the diagram below. Use five (5) hooks for
each side.
TOP VIEW
Photo shows the open end of the hook lag
facing the end panels.
Door Frame
Roll-up
Panel
Grommet
holes
Cover is not shown.
3. Tie a length of rope to the first grommet hole below the
guide post bracket, loop it around the first hook lag,
and lace it back through the next grommet. Repeat this
process until the rope is through the last grommet.
4. Leaving some slack, loosely tie the rope off at the
bottom grommet hole.
5. Repeat steps 1 through 4 for the other side of the door
frame.
6. Once the ropes on both sides are laced and hooked
in the correct position, untie the rope at the bottom
grommet holes, pull tight to remove excess slack, and
tie off at the bottom grommet holes.
7. Repeat for the remaining end.
NOTE:
Use the included zipper extension pole
(CC2235) to unhook the rope to open the roll-up panel.
The pole can also be used to loop the rope back onto
the hook lags when the roll-up panel is closed.
8. Read the
Install the Wind Panel
information that
follows. Applies to drop-down sides only.
Tie rope tight to the
first grommet hole
below the bracket.
Hook lags
Grommet holes
Roll-up
Panel
White dashed line shows the rope
laced behind the roll-up panel.
Guide post is
not shown.
