- 193 -
CT-S310
• Setting MSW 1 (a=1)
n b (Set Value)
Function
1
48 (Default)
Reports the power on.
49
Does not report power on.
2
48 (Default)
Sets input buffer capacity to 4K bytes.
49
Sets input buffer capacity to 45 bytes.
3
48 (Default)
Sets input buffer full and offline to be Busy.
49
Sets to be busy with input buffer full.
4
48 (Default)
At the occurrence of receiving error, replaces the data with
“?”.
49
At the occurrence of receiving error, ignores the data.
5
48 (Default)
Disables CR (0DH).
49
Enables CR (0DH).
6 48 (Default)
Reserved
7
48 (Default)
Does not reset at serial I/F pin 6.
49
Resets at serial I/F pin 6.
8
48 (Default)
Does not reset at serial I/F pin 25.
49
Resets sat serial I/F pin 25.
• Setting MSW 2 (a=2)
n b (Set Value)
Function
1 49 (Default)
Reserved
2
48
Disables auto cutter.
49 (Default)
Enables auto cutter.
3
48 (Default)
Enables stored printing.
49
Disables stored printing.
4
48 (Default)
Immediately after digit reaches full, line-feed is taken.
49
Immediately after digit reaches full, data wait is taken.
5
48 (Default)
After cover close and PE recovery, prints as it is.
49
After cover close and PE recovery, prints from the
beginning using PAGE MODE, barcode, image,
double-height printing, etc. as a unit.
6
48 (Default)
Sets paper width to 80 mm.
49
Sets paper width to 58 mm.
7 48 (Default)
Reserved
8
48 (Default)
Enables PNE.
49
Disables PNE.
• Setting MSW 3 (a=3)
n b (Set Value)
Function
1
48 (Default)
After clearing cutter error, can be restored by Feed SW.
49
After clearing cutter error, cannot be restored by Feed SW.
2 48 (Default)
Reserved
3
48 (Default)
Resets with parallel pin 31.
49
Does not reset with parallel pin 31.
4
48 (Default)
Uses thermal paper.
49
Uses Black mark paper.
5
48 (Default)
Used with 48/32 print columns.
49
Used with 42/30 print columns.
6 48 (Default)
Reserved
7
48 (Default)
Sets EPSON compatible mode.
49
Sets CBM1000-compatible mode.
8
48 (Default)
Sets cover open error during printing to be auto recovery
error.
49
Sets cover open error during printing to be recoverable
error.
• Setting MSW 4 (a=4)
n b (Set Value)
Function
1
48 (Default)
At the selection of Black mark paper, disables auto
end-measurement.
49
At the selection of Black mark paper, enables auto
end-measurement.
2
48
At the selection of Black mark paper, sets sensor position to
be on the printing side.
49 (Default)
At the selection of Black mark paper, sets sensor position to
be on the back of the printing side.
3
48
Paper heading cut disabled.
49 (Default)
Paper heading cut enabled.
4 48 (Default)
Reserved
5 48 (Default)
Reserved
6 48 (Default)
Reserved
7 48 (Default)
Reserved
8
48
Forcible partial cut disabled.
49 (Default)
Forcible partial cut enabled (full but by command:
enabled).
* MSW 4-1, MSW4-2 are valid when MSW 3-4 is ON.
