Citizen CT-P29 Series, Command Reference Manual

Page: 57 / 428

- 56 -
ESC SP n
Support model
CT-S280 CT-S300 CT-S2000 CT-S4000 CT-S251
CT-S281 CT-S310 CT-S801/851 CT-S601/651 CT-P29x series CT-S310 II
[Function] Setting the right spacing of the character
[Code] <1B>H<20>H<n>
[Range]
0≤n≤255
[Outline] [The specification which is common to the model]
• Sets the right spacing of character to [n×basic calculation pitch] inches.
[Caution] [The specification which is common to the model]
• If the horizontal magnification of character is 2 or more, the right spacing increases with the
magnification.
• Does not affect Kanji.
• The right spacing can be set separately for the STANDARD and PAGE MODES.
• The basic calculation pitch is set by GS P. Once defined, the right spacing is not changed if the basic calculation
pitch is changed by GS P.
• Fractions resulting from calculation are corrected with the minimum pitch of the mechanism, and the
remainder is omitted.
• In STANDARD MODE, this command uses the horizontal basic calculation pitch (x).
• In PAGE MODE, the basic calculation pitch used by this command depends on the start point:
(1) If the start point specified by ESC T is top left or bottom right, the command uses the horizontal basic
calculation pitch (x).
(2) If the start point specified by ESC T is top right or bottom left, the command uses the vertical basic
calculation pitch (y).
• The maximum right spacing is capable of approximately 31.906 mm (255/203 inches). A setting greater
than this maximum is trimmed to the maximum.
[Default] n=0
[The specification which depend on the model]
CT-S801(II) / CT-S851(II) / CT-S601(II) / CT-S651(II) / CT-S251
MSW6-2 ON : n=0
MSW6-2 OFF: n=1
[See Also] GS P
[Sample Program] [Print Results]
LPRINT CHR$(&H1B);" "; CHR$(0);
LPRINT "AAAAA"; CHR$(&HA);
LPRINT CHR$(&H1B);" "; CHR$(1);
LPRINT "AAAAA"; CHR$(&HA);
LPRINT CHR$(&H1B);" "; CHR$(12);
LPRINT "AAAAA"; CHR$(&HA);
ＡＡＡＡＡ
Ａ Ａ Ａ Ａ Ａ
Ａ Ａ Ａ Ａ Ａ
0-dot space
1-dot space
12-dots space