- 53 -
ESC J n
Support model
CT-S280
CT-S300
CT-S2000
CT-S4000
CT-S251
CT-S281
CT-S310
CT-S801/851
CT-S601/651 CT-P29x series
CT-S310II
[Function]
Printing and feeding paper in minimum pitch
[Code]
<1B>H<4A>H<n>
[Range]
0≤n≤255
[Outline]
[The specification which is common to the model]
• Prints the data held in the print buffer and feeds paper by [n×basic calculation pitch] inches.
[Caution]
[The specification which is common to the model]
• After this command is executed, the beginning of the line is taken as the start position for the next print.
• The line feed width can be set separately for the STANDARD and PAGE MODES.
• This command does not affect the line feed width defined by ESC 2 or ESC 3.
• The basic calculation pitch is set by GS P.
• Fractions resulting from calculation are corrected with the minimum pitch of the mechanism, and the
remainder is omitted.
• In STANDARD MODE, this command uses the vertical (paper feed direction) basic calculation pitch (y).
• In PAGE MODE, this command acts differently depending on the start point:
(1) If the start point specified by ESC T is top left or bottom right, the command uses the vertical (Paper
feed direction) basic calculation pitch (y).
(2) If the start point specified by ESC T is top right or bottom left, the command uses the horizontal
(Perpendicular to the paper feed direction) basic calculation pitch (x).
• The maximum settable line feed width is 1016 mm (40 inches). A setting greater than this maximum is
trimmed to the maximum.
[Default]
The initial value is not defined.
