Cisco UCS C890 M5, Instruction Manual

Page: 69 / 191

Contents Page 71
4.3.10.6 Installing Internal Hard Drives
To remove the cover of the storage module, depress the two release buttons and
push the cover toward the rear of the module as shown below.
2.5" HDDs.
The 2.5" hard drives are mounted in brackets or directly secured to the bottom of the
storage module tray. See Figure 3-16 below for the case with brackets.
1.
Remove the bracket (if any) holding the drive you wish to replace by
unscrewing from the bottom of the storage module.
2. Each drive is held in place in the bracket (if any) with four screws. Remove
these as well as the SATA power and data cables then take out the hard
drive.
3. Install a new hard drive into the bracket (if needed), reconnect the power
and data cables and secure the drive with the four screws.
4. Repeat the steps above as necessary.
5. With all brackets and their drives installed in the module, replace the cover
and slide the storage module back into its bay in the chassis.
6. Depress the power button to boot up the system.
Release Button
Release Button