Cisco Prisma II, Installation Manual

Page: 78 / 184

Chapter 3 Operation Using CLI
52 78-4025693-01 Rev D
A typical response to this command is shown in the sample craft operator dialog
below:
CLI> icim <Enter>
ICIM> show traps
IDX STATE IP Address
0 Enabled 172.18.50.41
1 Enabled 172.18.50.1
2 Enabled 172.18.50.6
3 Disabled 0.0.0.0
4 Disabled 0.0.0.0
SUCCESS!
ICIM>
Show Clock
Note that the show command supports access to the ICIM real time clock (RTC), as
follows:
ICIM> show clock exit
MM-DD-YYYY HH:mm:ss
11-15-2005 12:01:40
SUCCESS!
ICIM>
Set Command
The set command allows a single value to be set in the ICIM. The basic syntax is:
set argument value
Where argument is one of the values listed in the following table.
Value Function
CLLI Common Language Locator ID code for the ICIM
CLOCK Date and Time as maintained by the ICIM
COMMREAD SNMP Read Community string
COMMWRITE SNMP Write Community string
COMMTRAP SNMP Trap Community string
GATEWAY IP address of the TCP/IP gateway, for packet routing
IP TCP/IP address of the ICIM
STATUSMSG Error or Status message
SUBNET Subnet mask, such as 255.255.255.0
UPDATEID Write-only; value of 1 causes ICIM to re-read ID of all modules
Some of these values (IP and GATEWAY, for example) result in changes to the ICIM
NVRAM, but do not take effect until the next reboot.