Chapter 3 Operation Using CLI
48
78-4025693-01 Rev D
ICIM Commands
ICIM commands provide for monitoring and control of the ICIM itself and for the
ICIM domain in general.
Alarm Command
The
alarm
command is used to display all active alarms in the domain of the ICIM.
The following sample dialog illustrates the use of this command:
ICIM> alarm <Enter>
No active alarms found
SUCCESS!
ICIM>
This response indicates that no alarms are currently active anywhere in the ICIM
domain. To narrow the command scope to specific chassis or modules, use this
command in Module mode together with the
module
option, as described in
Module
Commands
(on page 38).
Info Command
The
info
command is used to request a listing of one or more parameter values
specific to the ICIM module itself.
The general command syntax is as follows:
info argument argument ... argument
where each
argument
can have one of the values listed in the table below.
Value
Function
ACTIVEREV
Active software image revision for the ICIM
ATTNSTATUS
Value for the Attention line (Low is normal)
BOOTREV
Current boot image revision for the ICIM
CHASSIS
Chassis containing the ICIM
CLEI
Common Language Equipment ID code for the ICIM
CLLI
Common Language Locator ID code for the ICIM
COMMREAD
Sets the SNMP Community Read string
COMMTRAP
Sets the SNMP Community Trap string
COMMWRITE
Sets the SNMP Community Write string
DEVTYPE
Devtype for the ICIM2 or ICIM2-XD
DOWNLDCMD
Download command (used by SOUP)
Summary of Contents for Prisma II
