Cisco Prisma II, Installation Manual

Page: 130 / 184

Chapter 5 Operation Using LCI
104 78-4025693-01 Rev D
LCI Introduction
Laser Warning
WARNING:

Avoid personal injury! Use of controls, adjustments, or procedures other
than those specified herein may result in hazardous radiation exposure.
 Avoid personal injury! The laser light source on this equipment (if a
transmitter) or the fiber cables connected to this equipment emit invisible
laser radiation. Avoid direct exposure to the laser light source.
 Avoid personal injury! Viewing the laser output (if a transmitter) or fiber
cable with optical instruments (such as eye loupes, magnifiers, or
microscopes) may pose an eye hazard.

Do not apply power to this equipment if the fiber is unmated or unterminated.

Do not stare into an unmated fiber or at any mirror-like surface that could reflect
light emitted from an unterminated fiber.

Do not view an activated fiber with optical instruments such as eye loupes,
magnifiers, or microscopes.

Use safety-approved optical fiber cable to maintain compliance with applicable
laser safety requirements.

Even if the unit is off, there may still be hazardous optical levels present.
LCI Function
LCI is software that functions as a user interface for the Prisma II platform. LCI is
installed on a computer, which is then connected to a Prisma II chassis. You can use
LCI to configure and monitor the modules in the chassis to which the computer is
connected.
Important: Do not operate any Prisma II chassis without a fan tray installed. If a fan
tray is not installed in the Prisma II chassis, the LCI will not communicate with any
of the modules in that chassis.