Cisco Prisma II, Installation Manual

Page: 80 / 184

Chapter 3 Operation Using CLI
54 78-4025693-01 Rev D
where

username must be 6 to 14 characters in length, must contain both letters and
numbers, and cannot contain special characters; for example, abc123.

authorization level is either admin, readwrite, or read.
Note:

After entering this command, you will be prompted to enter a password for the
user. The password must be 6 to 14 characters in length, must contain both letters
and numbers, but may contain special characters.

This command cannot be used to change the authorization level of the user. To
change authorization level, the user must be deleted and then added to the
system again, but specifying a different new authorization level.
User Delete
This command can be used by the Admin user to delete a login. The command
syntax is as follows:
user delete (username)
Note: Deleting a user that is already logged in does not terminate their current
session.
User Show
This command can be used by the Admin user to list all the available logins and
authorization levels. It does not display the passwords.
IPRoute Command
The iproute command permits control and monitoring of a list of up to four alternate
gateways for routing TCP/IP packets. The basic syntax is as follows:
iproute argument
where argument specifies whether the command is to add , delete , or show the route
information, as further explained below.
IPRoute Add
This command can be used to add a new entry to the list of alternate gateways for
routing TCP/IP packets. If the list already contains four entries, at least one entry
must be deleted using the iproute delete command before the new entry can be
added.
IPRoute Delete
This command can be used to remove an entry from the list of alternate gateways for
routing TCP/IP packets.