5-29
PA-MC-T3-EC Port Adapter Installation and Configuration
OL-10589-02
Chapter 5 Configuring the Channelized Mode
Checking the Configuration
Following is an example of the
show interfaces serial
command for a Cisco 7200 VXR router. In this
example, the port adapter is in slot 1 of a Cisco 7200 VXR router with an NPE-G1 or NPE-G2.
Router#
show interfaces serial 1/0/1:0
Serial 1/0/1:0 is up, line protocol is up
Hardware is PA-MC-2T3E
MTU 1500 bytes, BW 1536 Kbit, DLY 20000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation HDLC, crc 16, loopback not set
Keepalive not set
Last input 00:00:08, output 03:29:07, output hang never
Last clearing of "show interface" counters 01:08:09
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: weighted fair
Output queue: 0/1000/64/0 (size/max total/threshold/drops)
Conversations 0/1/256 (active/max active/max total)
Reserved Conversations 0/0 (allocated/max allocated)
Available Bandwidth 1152 kilobits/sec
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
73 packets input, 22338 bytes, 0 no buffer
Received 71 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
70 packets output, 19838 bytes, 0 underruns
0 output errors, 0 collisions, 1 interface resets
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions
(additional displayed text not shown)
Using the show controllers Command
You can display information for all T1 lines within a PA-MC-T3-EC with the
show controllers T3
slot/port-adapter/port
[
brief
|
tabular
|
remote performance
] command where:
•
brief
displays a list of configurations only.
•
tabular
displays a list of configurations and MIB data in a tabular format.
•
remote performance
displays a list of performance data from the remote end of a T1 connection.
Note
If you use the
show controllers T3
slot/port-adapter/port
command without one of the three optional
arguments (
brief
,
tabular
, or
remote performance
), all information is displayed for the T3 controller
you specified; therefore, the resulting display output can be extensive.
You can also display brief configuration information or tabular configuration and MIB information about
a specific T1 line within a PA-MC-T3-EC with the
show controllers T3
slot/port-adapter/t3-port/t1-line-number
[
brief
|
tabular | remote performance
] command where:
•
t1-line-number
is 1 to 28.
•
brief
displays a list of configurations only.
•
tabular
displays a list of configurations and MIB data in a tabular format.
•
remote performance
displays performance data from the remote T1 equipment.
The syntax is as follows:
•
show controllers T3
chassis-slot/t3-port
brief
