4-15
PA-MC-T3-EC Port Adapter Installation and Configuration
OL-10589-02
Chapter 4 Configuring the Unchannelized Mode
Checking the Configuration
Step 4
Add any additional configuration subcommands required to enable routing protocols and set the
interface characteristics.
Step 5
Re enable the interfaces using the
no shutdown
command. (See the
“Replacing an Existing Port
Adapter” section on page 4-3
.)
Step 6
Configure all additional port adapter interfaces as required.
Step 7
After including all of the configuration subcommands to complete your configuration, press
Ctrl-Z
—hold down the
Control
key while you press
Z
—or enter
end
or
exit
to exit configuration mode
and return to the EXEC command interpreter prompt.
Step 8
Write the new configuration to NVRAM as follows:
Router#
copy running-config startup-config
[OK]
Router#
This completes the procedure for creating a basic configuration.
Checking the Configuration
After configuring the new interface, use the
show
commands to display the status of the new interface
or all interfaces, and use the
ping
and
loopback
commands to check connectivity. This section includes
the following subsections:
•
Using show Commands to Verify the New Interface Status, page 4-15
•
Using the ping Command to Verify Network Connectivity, page 4-20
•
Using loopback Commands to Troubleshoot Network Problems, page 4-20
Using show Commands to Verify the New Interface Status
Table 4-3
demonstrates how you can use the
show
commands to verify that new interfaces are configured
and operating correctly and that the PA-MC-T3-EC appears in them correctly. Sample displays of the
output of selected
show
commands appear in the sections that follow. For complete command
descriptions and examples, refer to the publications listed in the
“Related Documentation” section on
page iv
.
Note
The outputs that appear in this document may not match the output you receive when running these
commands. The outputs in this document are examples only.
