4-19
PA-MC-T3-EC Port Adapter Installation and Configuration
OL-10589-02
Chapter 4 Configuring the Unchannelized Mode
Checking the Configuration
Using the show interfaces Command
The
show interfaces serial
command displays status information (including the physical slot and
interface address) for the interfaces you specify.
For complete descriptions of interface subcommands and the configuration options available for
Cisco 7200 VXR router interfaces, refer to the publications listed in the
“Related Documentation”
section on page iv
.
Note
The outputs that appear in this document may not match the output you receive when running these
commands. The outputs in this document are examples only.
Following is an example of the
show interfaces serial
command for Cisco 7200 VXR routers. In this
example, the port adapter is in slot 5 of a Cisco 7200 VXR router:
Router#
show interfaces serial 1/0/1:0
Serial 1/0/1:0 is up, line protocol is up
Hardware is PA-MC-2T3E
MTU 1500 bytes, BW 1536 Kbit, DLY 20000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation HDLC, crc 16, loopback not set
Keepalive not set
Last input 00:00:08, output 03:29:07, output hang never
Last clearing of "show interface" counters 01:08:09
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: weighted fair
Output queue: 0/1000/64/0 (size/max total/threshold/drops)
Conversations 0/1/256 (active/max active/max total)
Reserved Conversations 0/0 (allocated/max allocated)
Available Bandwidth 1152 kilobits/sec
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
73 packets input, 22338 bytes, 0 no buffer
Received 71 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
70 packets output, 19838 bytes, 0 underruns
0 output errors, 0 collisions, 1 interface resets
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions
(additional displayed text not shown)
Using the show controllers Command
You can display information for the T3 controller within a PA-MC-T3-EC in Cisco 7200 VXR routers
with the
show controllers t3
port-adapter/t3-port
[
brief
|
tabular
] command where:
•
brief
displays a list of configurations only.
•
tabular
displays a list of configurations and MIB data in a tabular format.
Note
If you use the
show controllers t3
port-adapter/t3-port
command without either of the optional
arguments (
brief
or
tabular
), all information is displayed for the T3 controller you specified; therefore,
the resulting display output can be extensive.
