5-28
PA-MC-T3-EC Port Adapter Installation and Configuration
OL-10589-02
Chapter 5 Configuring the Channelized Mode
Checking the Configuration
Using the show diag Command
Display the types of port adapters installed in your system (and specific information about each) using
the
show diag
slot
command, where
slot
is the
port adapter slot
in a Cisco 7200 VXR router (with an
NPE-G1 or NPE-G2).
Note
The outputs that appear in this document may not match the output you receive when running these
commands. The outputs in this document are examples only.
Following is an example of the
show diag
slot
command that shows a PA-MC-T3-EC in port adapter
slot 2 of a Cisco 7200 VXR router with an NPE-G1 or NPE-G2.
Router#
show diag 2
Slot 2:
Enhanced 2 port T3 multichannel Port adapter, 2 ports
Port adapter is analyzed
Port adapter insertion time 00:00:50 agoh
EEPROM contents at hardware discovery:
PCB Serial Number : JAE103394R8
Hardware Revision : 1.1
Part Number : 73-10698-02
Board Revision : 06
RMA Test History : 00
RMA Number : 0-0-0-0
RMA History : 00
Deviation Number : 85586
Product (FRU) Number : PA-MC-2T3-EC
Version Identifier : V01
Top Assy. Part Number : 68-2713-02
CLEI Code :
EEPROM format version 4
EEPROM contents (hex):
0x00: 04 FF C1 8B 4A 41 45 31 30 33 33 39 34 52 38 40
0x10: 05 44 41 01 01 82 49 29 CA 02 42 30 36 03 00 81
0x20: 00 00 00 00 04 00 88 00 01 4E 52 CB 94 50 41 2D
0x30: 4D 43 2D 32 54 33 2D 45 43 20 20 20 20 20 20 20
0x40: 20 89 56 30 31 20 D9 03 C1 40 CB 87 44 0A 99 02
0x50: C6 8A 20 20 20 20 20 20 20 20 20 20 FF FF FF FF
0x60: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF
0x70: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF
Using the show interfaces Command
The
show interfaces
command displays status information (including the physical slot and interface
address) for the interfaces you specify. Following is an example that specifies serial interfaces.
For complete descriptions of interface subcommands and the configuration options available for
Cisco 7200 VXR routers, refer to the publications listed in the
“Related Documentation” section on
page iv
.
Note
The outputs that appear in this document may not match the output you receive when running these
commands. The outputs in this document are examples only.
