Cisco Nexus 7004, Hardware Installation And Reference Manual

Page: 185 / 508

C H A P T E R
7-1
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
OL-23069-07
7
Connecting the Cisco Nexus 7000 Series Switch
to the Network
This chapter describes how to connect the Cisco Nexus 7000 Series switch (configure its IP address
through a console, set up its management interface, and connect its Ethernet ports to the network) after
it has been installed in its rack or cabinet.
This chapter includes the following sections:
•
Preparing for Connections, page 7-1
•
Required Tools and Equipment, page 7-1
•
Connecting to the Console, page 7-2
•
Creating an Initial Switch Configuration, page 7-3
•
Setting Up the Management Interface, page 7-4
•
Connecting the Supervisor CMP Port, page 7-5
•
Connecting an I/O Module, page 7-6
Preparing for Connections
When preparing your site for network connections to the Cisco Nexus 7000 Series switch, consider the
following for each type of interface:
•
Cabling required for each interface type
•
Distance limitations for each signal type
•
Additional interface equipment needed
Before installing the switch, have all additional external equipment and cables available.
Required Tools and Equipment
•
Console cable connector kit—You can find this kit in the accessory kit, which ships with the Cisco
Nexus 7000 Series switch.
•
Network cabling—You have already routed the network cables to the location of the installed Cisco
Nexus 7000 Series switch.