Cisco Nexus 7004, Hardware Installation And Reference Manual

Page: 140 / 508

5-18
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
OL-23069-07
Chapter 5 Installing a Cisco Nexus 7018 Chassis
Installing the Cable Management Frame
Step 3
Attach an upper cable management assembly (800-31342-01) onto the two hooks that protrude from the
upper half of the left rack-mount bracket that is attached to the Cisco Nexus 7018 switch chassis, and
loosely fasten the assembly to the chassis with four flat-head M4x10 screws as shown in
Figure 5-9 .
Figure 5-9 Attaching a Left Cable Management Assembly to a Rack-Mount Bracket
Step 4
Repeat Step 3 to attach an upper cable management assembly to the upper right side of the chassis. When
completed, the chassis will appear as shown in
Figure 5-10 .
1 Rack-mount bracket. 3 Position the assembly so that the two upper hooks on
the rack-mount bracket fit inside the two holes on the
assembly, and then slide the assembly down so that it is
held by the hooks.
2
Upper cable management assembly.
4
Loosely fasten the assembly to the rack-mount bracket
with four M4x10 screws. Do not tighten these screws.