Cisco ME 3400 Series, Software Configuration Manual

Page: 55 / 1138

1-11
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
OL-9639-07
Chapter 1 Overview
Default Settings After Initial Switch Configuration
•
IP SLAs for Metro Ethernet using IEEE 802.1ag Ethernet Operation, Administration, and
Maintenance (OAM) capability to validate connectivity, jitter, and latency in a metro Ethernet
network (requires metro IP access or metro access image)
• Embedded event manager (EEM) for device and system management to monitor key system events
and then act on them though a policy (requires metro IP access or metro access image)
Default Settings After Initial Switch Configuration
The switch is designed for plug-and-play operation; you only need to assign basic IP information to the
switch and connect it to the other devices in your network. If you have specific network needs, you can
change the interface-specific and system-wide settings.
Note For information about assigning an IP address by using the CLI-based setup program, see the hardware
installation guide.
If you do not configure the switch at all, the Cisco ME 3400 switch operates with the default settings
shown in
Table 1-1 .
Table 1-1 Default Settings After Initial Switch Configuration
Feature Default Setting More information in...
Switch IP address, subnet mask, and
default gateway 0.0.0.0 Chapter 3, “Assigning the Switch IP
Address and Default Gateway”
Domain name None
Passwords None defined Chapter 5, “Administering the Switch”
Disabled
RADIUS Disabled
System name and prompt Switch
NTP Enabled
DNS Enabled
IEEE 802.1x Disabled Chapter 8, “Configuring IEEE 802.1x
Port-Based Authentication”
DHCP
•
DHCP client Enabled Chapter 3, “Assigning the Switch IP
Address and Default Gateway”
Chapter 19, “Configuring DHCP Features
and IP Source Guard”
•
DHCP server Enabled if the device acting as a DHCP
server is configured and is enabled
• DHCP relay agent Enabled (if the device is acting as a
DHCP relay agent and is configured and
enabled)
Port parameters