9-23
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
OL-9639-07
Chapter 9 Configuring Interfaces
Configuring Layer 3 Interfaces
Note
When you create an SVI, it does not become active until it is associated with a physical port.
For information about assigning Layer 2 ports to VLANs, see
Chapter 11, “Configuring
VLANs.”
•
Routed ports: Routed ports are physical ports configured to be in Layer 3 mode by using the
no
switchport
interface configuration command.
•
Layer 3 EtherChannel ports: EtherChannel interfaces made up of routed ports.
EtherChannel port interfaces are described in
Chapter 34, “Configuring EtherChannels and
Link-State Tracking.”
A Layer 3 switch can have an IP address assigned to each routed port and SVI.
There is no defined limit to the number of SVIs and routed ports that can be configured in a switch.
However, the interrelationship between the number of SVIs and routed ports and the number of other
features being configured might have an impact on CPU usage because of hardware limitations. If the
switch is using maximum hardware resources, attempts to create a routed port or SVI have these results:
•
If you try to create a new routed port, the switch generates a message that there are not enough
resources to convert the interface to a routed port, and the interface remains as a switch port.
•
If you try to create an extended-range VLAN, an error message is generated, and the extended-range
VLAN is rejected.
•
If the switch attempts to boot up with a configuration that has more VLANs and routed ports than
hardware can support, the VLANs are created, but the routed ports are shut down, and the switch
sends a message that this was due to insufficient hardware resources.
All Layer 3 interfaces require an IP address to route traffic. This procedure shows how to configure an
interface as a Layer 3 interface and how to assign an IP address to an interface.
Note
If the physical port is in Layer 2 mode (the default), you must enter the
no switchport
interface
configuration command to put the interface into Layer 3 mode. Entering a
no switchport
command
disables and then re-enables the interface, which might generate messages on the device to which the
interface is connected. Furthermore, when you put an interface that is in Layer 2 mode into Layer 3
mode, the previous configuration information related to the affected interface might be lost, and the
interface is returned to its default configuration
Beginning in privileged EXEC mode, follow these steps to configure a Layer 3 interface:
Command
Purpose
Step 1
configure terminal
Enter global configuration mode.
Step 2
interface
{{
fastethernet
|
gigabitethernet
}
interface-id
}
| {
vlan
vlan-id
} | {
port-channel
port-channel-number
}
Specify the interface to be configured as a Layer 3
interface, and enter interface configuration mode.
Step 3
no shutdown
Enable the port, if necessary. By default, UNIs and ENIs
are disabled, and NNIs are enabled.
Step 4
no switchport
For physical ports only, enter Layer 3 mode.
Step 5
ip address
ip_address subnet_mask
Configure the IP address and IP subnet.
Step 6
no shutdown
Enable the interface.
Step 7
end
Return to privileged EXEC mode.
Summary of Contents for ME 3400 Series
Page 40: ...Contents xl Cisco ME 3400 Ethernet Access Switch Software Configuration Guide OL 9639 07 ...
Page 44: ...xliv Cisco ME 3400 Ethernet Access Switch Software Configuration Guide OL 9639 07 Preface ...
Page 1138: ...Index IN 52 Cisco ME 3400 Ethernet Access Switch Software Configuration Guide OL 9639 07 ...
