9-9
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
OL-9639-07
Chapter 9 Configuring Interfaces
Using Interface Configuration Mode
Step 4
Follow each
interface
command with the interface configuration commands that the interface requires.
The commands that you enter define the protocols and applications that will run on the interface. The
commands are collected and applied to the interface when you enter another interface command or enter
end
to return to privileged EXEC mode.
You can also configure a range of interfaces by using the
interface range
or
interface range macro
global configuration commands. Interfaces configured in a range must be the same type and must be
configured with the same feature options.
Step 5
After you configure an interface, verify its status by using the
show
privileged EXEC commands listed
in the
“Monitoring and Maintaining the Interfaces” section on page 9-26
.
Enter the
show interfaces
privileged EXEC command to see a list of all interfaces on or configured for
the switch. A report is provided for each interface that the device supports or for the specified interface.
Configuring a Range of Interfaces
You can use the
interface range
global configuration command to configure multiple interfaces with the
same configuration parameters. When you enter the interface range configuration mode, all command
parameters that you enter are attributed to all interfaces within that range until you exit this mode.
Beginning in privileged EXEC mode, follow these steps to configure a range of interfaces with the
same parameters:
When using the
interface range
global configuration command, note these guidelines:
•
Valid entries for
port-range
:
–
vlan
vlan-ID
-
vlan-ID
, where the VLAN ID is 1 to 4094
–
fastethernet
module/{first
port
} - {
last port
}, where the module is always 0
Command
Purpose
Step 1
configure terminal
Enter global configuration mode.
Step 2
interface range
{
port-range
}
Specify the range of interfaces (VLANs or physical ports) to be
configured, and enter interface range configuration mode.
•
You can use the
interface range
command to configure up to five
port ranges or a previously defined macro.
•
In a comma-separated
port-range
, you must enter the interface
type for each entry and enter spaces before and after the comma.
•
In a hyphen-separated
port-range
, you do not need to re-enter the
interface type, but you must enter a space before the hyphen.
Step 3
no shutdown
Enable the port, if necessary. By default, UNIs and ENIs are disabled,
and NNIs are enabled.
Step 4
You can now use the normal configuration commands to apply the
configuration parameters to all interfaces in the range.
Step 5
end
Return to privileged EXEC mode.
Step 6
show interfaces
[
interface-id
]
Verify the configuration of the interfaces in the range.
Step 7
copy running-config startup-config
(Optional) Save your entries in the configuration file.
Summary of Contents for ME 3400 Series
Page 40: ...Contents xl Cisco ME 3400 Ethernet Access Switch Software Configuration Guide OL 9639 07 ...
Page 44: ...xliv Cisco ME 3400 Ethernet Access Switch Software Configuration Guide OL 9639 07 Preface ...
Page 1138: ...Index IN 52 Cisco ME 3400 Ethernet Access Switch Software Configuration Guide OL 9639 07 ...
