Cisco ME 3400 Series, Software Configuration Manual

Page: 273 / 1138

11-27
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
OL-9639-07
Chapter 11 Configuring VLANs
Configuring VMPS
To return an interface to its default configuration, use the default interface interface-id interface
configuration command. To reset the access mode to the default VLAN for the switch, use the no
switchport access vlan interface configuration command.
Reconfirming VLAN Memberships
Beginning in privileged EXEC mode, follow these steps to confirm the dynamic-access port VLAN
membership assignments that the switch has received from the VMPS:
Changing the Reconfirmation Interval
VMPS clients periodically reconfirm the VLAN membership information received from the VMPS.You
can set the number of minutes after which reconfirmation occurs.
Beginning in privileged EXEC mode, follow these steps to change the reconfirmation interval:
To return the switch to its default setting, use the no vmps reconfirm global configuration command.
Changing the Retry Count
Beginning in privileged EXEC mode, follow these steps to change the number of times that the switch
attempts to contact the VMPS before querying the next server:
To return the switch to its default setting, use the no vmps retry global configuration command.
Command Purpose
Step 1 vmps reconfirm Reconfirm dynamic-access port VLAN membership.
Step 2
show vmps Verify the dynamic VLAN reconfirmation status.
Command Purpose
Step 1 configure terminal Enter global configuration mode.
Step 2
vmps reconfirm minutes Enter the number of minutes between reconfirmations of the dynamic
VLAN membership. The range is 1 to 120. The default is 60 minutes.
Step 3
end Return to privileged EXEC mode.
Step 4 show vmps Verify the dynamic VLAN reconfirmation status in the Reconfirm Interval
field of the display.
Step 5 copy running-config startup-config (Optional) Save your entries in the configuration file.
Command Purpose
Step 1 configure terminal Enter global configuration mode.
Step 2
vmps retry count Change the retry count. The retry range is 1 to 10; the default is 3.
Step 3 end Return to privileged EXEC mode.
Step 4 show vmps Verify your entry in the Server Retry Count field of the display.
Step 5 copy running-config startup-config (Optional) Save your entries in the configuration file.