4-22
Installing Cisco Intrusion Prevention System Appliances and Modules 5.0
78-16124-01
Chapter 4 Installing IDS-4235 and IDS-4250
Installing the Accessories
To install the cable-management arm, follow these steps:
Step 1
Facing the back of the rack cabinet, locate the latch on the end of the right slide assembly that you
secured to the back vertical rail.
Step 2
Push the tab on the back end of the cable-management arm into the latch on the end of the slide assembly
(see
Figure 4-8 on page 4-23
).
Note
The latch clicks when locked.
Step 3
Push the tab on the remaining free end (the front) into a mating latch on the inner segment of the slide
assembly (see
Figure 4-8 on page 4-23
).
Note
The latch clicks when locked.
Step 4
Install a stop block on the latch on the end of the opposite slide assembly (see
Figure 4-8 on page 4-23
).
Note
The stop block prevents the backward travel of the cable-management arm and supports the
weight of the arm with its load of installed cables.
Note
The two-post rack kit has two stop blocks: one for right-side mounting, and one for left-side
mounting. You can only install the proper stop block.