7-13
Installing Cisco Intrusion Prevention System Appliances and Modules 5.0
78-16124-01
Chapter 7 Installing IDSM-2
Resetting IDSM-2
Cisco IOS Software
Use the hw-module module module_number reset mem-test-full command to enable a full memory
test. The full memory test takes about 12 minutes.
To enable a full memory test, follow these steps:
Step 1
Log in to the console.
Step 2
Enable the full memory test:
router#
hw-module module 9 reset mem-test-full
Device BOOT variable for reset = <empty>
Warning: Device list is not verified.
Proceed with reload of module?[confirm]
% reset issued for module 9
router#
Step 3
Reset IDSM-2.
The full memory test runs.
Note
A full memory test takes more time to complete than a partial memory test.
Resetting IDSM-2
If for some reason you cannot communicate with IDSM-2 through SSH, Telnet, or the switch session
command, you must reset IDSM-2 from the switch console. The reset process requires several minutes.
This section describes how to reset IDSM-2, and contains the following topics:
•
Catalyst Software, page 7-13
•
Cisco IOS Software, page 7-14
Catalyst Software
To reset IDSM-2 from the CLI, follow these steps:
Step 1
Log in to the console.
Step 2
Enter privileged mode:
console>
enable
Step 3
Reset IDSM-2 to the application partition or the maintenance partition:
console> (enable)
reset
module_number
[
hdd:1 | cf:1
]