4-16
Installing Cisco Intrusion Prevention System Appliances and Modules 5.0
78-16124-01
Chapter 4 Installing IDS-4235 and IDS-4250
Installing the Accessories
Figure 4-5
shows the SCSI hard-disk drive indicators.
Figure 4-5
SCSI Hard-Disk Drive
When you have installed the new hard-disk drive, you must reimage it with the recovery/upgrade CD.
For the procedure, refer
Using the Recovery/Upgrade CD
.
This section contains the following topics:
•
Removing the SCSI Hard-Disk Drive, page 4-16
•
Replacing the SCSI Hard-Disk Drive, page 4-17
Removing the SCSI Hard-Disk Drive
To remove the SCSI hard-disk drive, follow these steps:
Step 1
Log in to the CLI.
Step 2
Prepare the appliance to be powered off:
sensor#
reset powerdown
Wait for the power down message before continuing with Step 3.
Note
You can also power down the sensor from IDM.
Step 3
Power off the appliance by pressing the power button.
Step 4
Remove the front bezel.
For the procedure, see
Installing and Removing the Bezel, page 4-10
.
Step 5
Open the hard-disk drive handle to release the drive.
Step 6
Slide the hard-disk drive out until it is free of the drive bay.
87959
Drive power-on (green)
Green drive-activity indicator