Cisco 8800 Series, Manual

Page: 509 / 544

• nme= XXXX is the name displayed on the phone for the speed-dial line key. Replace XXXX with a
name.
You can also configure the parameter in the configuration file (cfg.xml) by entering a string in the following
format:
fnc=xml;url=http://xml.service.url;nme=name
Step 4 Click
Submit All Changes
.
Add Call Park on a Key Expansion Module Line Key
You can add call park to a Key Expansion Module line key to enable the user to temporarily store calls to the
same phone to which the Key Expansion Module is connected or to store calls to a different phone. The user
can also unpark the call from the line key.
Before you begin
Access the phone administration web page. See Access the Phone Web Interface, on page 104 .
Procedure
Step 1
Select Voice > Att Console .
Step 2 Select a Key Expansion Module line key on which to enable the call park.
Step 3 Enter a string in this format:
For a private line, enter
fnc=park;sub=$USER@$PROXY;nme=CallPark-Slot1
For a shared line, enter
fnc=prk;sub=$USER@$PROXY;nme=Call-Park1;orbit=<DN of primary line>
where:
• fnc= prk means function=call park
• sub= 999999 is the phone to which the call parks. Replace 999999 with a numbers.
• nme= XXXX is the name displayed on the phone for the call park line key. Replace XXXX with a name.
You can also configure the line-specific parameter in the configuration file (cfg.xml). Enter a string in the
following format:
<Unit_1_Key_1_ ua="na">fnc=prk;sub=$USER@$PROXY;nme=CallPark-Slot1</Unit_1_Key_1_>
Step 4
Click Submit All Changes .
Cisco IP Phone 8800 Series Multiplatform Phone Administration Guide for Release 11.3(1) and Later
489
Cisco IP Phone Accessories
Add Call Park on a Key Expansion Module Line Key