Installing Cisco Interface Cards in Cisco Access Routers
Installing Cisco Interface Cards in Cisco Access Routers
11
OL-12842-01
Installing Slot Dividers in Cisco 2811, Cisco 2821, Cisco 2851, and Cisco 3825 Series Routers
To install a slot divider in Cisco 2811, Cisco 2821, Cisco 2851, and Cisco 3825 series routers, perform
the following steps:
Step 1
Remove any installed interface cards and blank faceplates from the router slot you plan to use.
Step 2
Guide the two halves of the slot divider between the two rails in the bottom of the interface card slot.
(See
Figure 21
.)
Step 3
Push the slot divider in until it seats and locks into place. When the slot divider is fully seated, its outer
end is flush with the front panel of the router. (See
Figure 22
.)
Figure 21
Inserting a Slot Divider into an Interface Card Slot
Step 4
Gently pull the slot divider to check for complete seating. If properly seated, it does not come out. (See
Figure 22
.)
117042
