BLEND OVERCURRENT (STORED) - MTC
When Monitored:
When actuator movement is requested.
Set Condition:
This DTC will set if the A/C - Heater Control Module detects an excessive
current draw on any of the door driver circuits while attempting to drive the passenger
blend door actuator. Only one overcurrent DTC can set per ignition cycle.
CHECKSUM FAILURE (STORED) - MTC
When Monitored:
With the ignition on.
Set Condition:
This DTC will set if the calculated check sum does not match the stored
value.
DEFOG SWITCH FAULT (STORED) - MTC
When Monitored:
With the ignition on.
Set Condition:
This DTC will set if the EBL switch stays closed for 10 minutes.
EVAPORATOR TEMPERATURE SENSOR CIRCUIT OPEN (STORED) - MTC
When Monitored:
With the ignition on.
Set Condition:
This DTC will set if the A/C - Heater Control Module sees abnormally high
voltage on the Evaporator Temperature Sensor Signal circuit.
EVAPORATOR TEMPERATURE SENSOR CIRCUIT SHORT (STORED) - MTC
When Monitored:
With the ignition on.
Set Condition:
This DTC will set if the A/C - Heater Control Module sees abnormally low
voltage on the Evaporator Temperature Sensor Signal circuit.
LOOPBACK TEST FAILURE (STORED) - MTC
When Monitored:
When the A/C - Heater Control Module executes an internal loopback
test.
Set Condition:
If the A/C - Heater Control Module fails to send a message, or none of the
expected messages arrive for 5 seconds, an internal loopback test is executed. If the
internal loopback test fails, the DTC will set.
MODE OVERCURRENT (STORED) - MTC
When Monitored:
When actuator movement is requested.
Set Condition:
This DTC will set if the A/C - Heater Control Module detects an excessive
current draw on any of the door driver circuits while attempting to drive this actuator.
Only one overcurrent DTC can set per ignition cycle.
NO FUEL LEVEL MESSAGE RECEIVED (STORED) - MTC
When Monitored:
With the ignition on.
Set Condition:
This DTC will set if the A/C - Heater Control Module does not receive the
Fuel Level message from the PCM for more than 5 seconds.
511
HEATING & A/C
A/C SWITCH FAULT (STORED) - MTC —
Continued
Summary of Contents for Caravan 2003
