Chrysler 1997 Stratus Convertible LHD, Service Manual, Page: 343 / 1196

HEADLAMP ADJUSTMENT
A properly aimed low beam headlamp will project
the center of the low beam hot spot on the alignment
screen 190 mm (7.5 in.) below the headlamp center-
line. The side-to-side low beam hot spot should be
127 mm (5 in.) right of headlamp centerline (Fig. 3).
The preferred headlamp alignment is 0 (
6
0.76°)
for the up/down adjustment as indicated on
bubble level. Preferred left/right alignment is 0
(
6
0.76°) as indicated on the gauge wheel. The
high beam headlamps cannot be aligned. The high
beam pattern should be correct when the low beams
are aligned properly.
NOTE: The bubble level and gauge wheel is cali-
brated before the headlamp is installed in the vehi-
cle. The bubble level cannot be calibrated without
damaging the headlamp module. If bubble level is
faulty, replace headlamp module.
To adjust headlamp alignment, rotate alignment
screws to achieve the specified low beam hot spot
pattern (Fig. 4).
Fig. 3 Headlamp Alignment Screen
CENTER OF VEHICLE CENTER OF HEADLAMPS 5
9
7.5
9
5
9
7.5
9
7.62 METERS (25 FT.) FRONT OF HEADLAMP
Fig. 4 Headlamp Alignment Screws
RADIATOR CLOSURE PANEL GAUGE WHEEL LEFT/RIGHT ADJUSTER BUBBLE VIAL HEADLAMP MODULE UP/DOWN ADJUSTER
JX
LAMPS 8L - 5
ADJUSTMENTS (Continued)