Chrysler 1997 Stratus Convertible LHD, Service Manual, Page: 141 / 1196

(2) Correctly isolate remote ground cable when ser-
vicing vehicle by installing the ground cable insulator
on the strut tower ground stud as shown (Fig. 102).
This will prevent accidental grounding of the
remote ground cable.
(3) Remove the PCV hose (Fig. 103) from the air
chamber located on the front of the intake manifold.
Remove bolt (Fig. 103) attaching the air chamber to
the intake manifold. Then unlatch lid of air cleaner
from air cleaner housing and loosen clamp attaching
air inlet hose to throttle body (Fig. 103). Remove the
air cleaner lid, air inlet hose and air chamber (Fig.
103) as an assembly from the engine.
(4) Remove the throttle cable and if equipped the
speed control cable from the throttle body (Fig. 104).
Remove the vacuum hose (Fig. 104) from the throttle
body. Remove the wiring harness connectors from
AIS motor and the Throttle Position Sensor (Fig.
104) on the throttle body. Then, remove the 4 bolts
(Fig. 104) attaching the throttle body to the intake
manifold and remove it from intake manifold.
(5) Without removing cables from bracket, remove
the throttle and speed control cable mounting
bracket (Fig. 104) from the intake manifold.
(6) Remove the EGR tube (Fig. 105) from the
intake manifold and EGR valve.
Fig. 102 Correctly Isolated Remote Ground Cable
LEFT STRUT TOWER
GROUNDSTUD
Fig. 103 Engine Air Intake System Components
INTAKE MANIFOLD THROTTLE BODY AIR INLET HOSE
AIR CLEANER LID
AIR CLEANER HOUSING PCV HOSE AIR CHAM- BER ATTACHINGBOLT
Fig. 104 Throttle Body Attachment To Intake
Manifold
INTAKE MANI- FOLD VACUUMHOSE THROTTLE BODY SPEED CONTROL AND THROTTLE CABLE CABLE BRACKET ELECTRICAL CONNECTOR AISMOTOR THROTTLE BODY MOUNT- ING BOLTS THROTTLE POSITION SENSOR ELECTRICAL CONNECTORS
Fig. 105 EGR Tube Attachment To Intake Manifold
And EGR Valve
INTAKE MANI- FOLD MOUNTING BOLTS EGR TUBE ASSEMBLY EGRVALVE MOUNTING BOLTS
JX
BRAKES 5 - 39
REMOVAL AND INSTALLATION (Continued)