Chromasens CD40127_R02 allPIXA_pro_User Manual.docx
196
9.11.4 Camera Link interface type and minimum line time (integration time)
Name
Name
Type of Camera Link interface
Function
Sets the output to Base, Medium, Full64 or Full80 mode
Channels
All
Unit
Integer
Dependency
None
Notes
For some modes, the line rates and integration time are limited. For
details, refer to the table below.
For some modes, the scan line length must be a multiple of x.
For details, refer to the table below.
For Base mode the Camera Link connector 1 must be used.
allPIXA pro-Mono supports only the first two modes 0.
Camera
Value
Function
Lower limit
All
Base
1Tx24b (1X1), for color output
2Tx8b, 2Tx10b or 2Tx12b
(2XE for mono output with the color camera)
Scan line length must be a multiple of 2.
All
Base 3Tx8Bit 1X3 Raw
Scan line length must be a multiple of 2.
All
Medium 2XE
2Tx24b (2XE RGB)
Scan line length must be a multiple of 2
All
Medium 1X2 (RGB, RAW)
2Tx24b (1X2, Raw)
Scan line length must be a multiple of 2.
All
Full64_8Tx8Bit 1X Raw,
RGB with 8 color planes per Camera Link clock.
Scan line length must be a multiple of 16.
All
Full80_8Tx10Bit 1X Raw
RGB with 8 color planes per Camera Link clock.
Scan line length must be a multiple of 16.
Upper limit
All
Full80_10Tx8Bit 1X Raw
RGB with 10 color planes per Camera Link clock
Scan line length must be a multiple of 2.
NOTE
If you work with Encoder and with low CameraLink speed, e.g. with Base
mode, make sure that the time between Encoder pulses is always longer
than line transmission time. Otherwise the images are erroneous and the
camera indicates this error at the
Speed2High
bit if
Info block in each
line
has been activated on the
Output format
page (see section
